Disabled Modules

External Disabled module positioned under seating

External Disabled modules positioned under temporary seating

External Disabled module interior view

External Disabled toilet module interior view

 

The Disabled Modules are units that are positioned ideally outside or even inside a structure. They come with ramps for access or the client may build their own flooring to reach the level of the floor.

  • Porcelain hand basin with hot and cold lever taps
  • Contrasting colour hand rails
  • Emergency lighting and alarm
  • Hand towel, loo paper and soap dispensers
  • Fully compliant with Doc M building regulations

The units are connected to a fresh water flush system emptying either into a waste tank provided by IGLOOS or linked to a mains drain via a 4” mains connection. There is no requirement for chemical. If the units are operating on a system requiring waste tanks, these should be situated outside a structure.

Requirements for operation

  • Equipment is delivered on an articulated lorry so access should be ensured for the vehicle and forklift access into position.
  • Constant power supply of a 16amp C form is required for installation and during the event.
  • Constant fresh water supply with good pressure for installation and during the event. The fresh water is necessary for both the hand basins and loo pan.

Accessories

  • Consumables – Scottish Fine Soaps and Hand Lotion, loo paper and paper hand towels are supplied as standard.

Module Layouts

1 WC, 1 hand basin
7'6" (2.34 m) length
5'2" (1.55 m) width
7'5" (2.30 m) high

Ramp             4" (1.2m)       (as required)

External Disabled toilet module layout

MV11_Disabled_Modules.pdf

You are here: Temporary Event Solutions Moduvac Disabled Modules